Manuals Assessment: Answer Key HP PhotosmartGoGo Photo Studio - 420 Series You are going to organize the HP PhotosmartGoGo Photo Studio manual. 1. Read the following instructions and identify which sub-heading they belong to: a. How to use b. Cleaning and maintenance c. Troubleshooting When the printer finishes cleaning the cartridge a test page will be printed. if you are using 10 x 30 cm (4 x 12 inches) photo paper for panoramic printing, do not load more than ten sheets in the In- tray. Loading more than 10 sheets of this type of paper can cause paper feed problems Remove anything that might be covering the sensor or obstructing the line of sight between it and the remote Unplug the printer power cord. Wait about 10 seconds, then plug the power cord back in. Adjust the paper-width guide to fit close to the edge of the paper without bending the paper. If the paper came part way through the front of the printer, gently pull the paper towards you to remove it. Browse the thumbnails by pressing the arrow buttons on the printer control panel Select Clean cartridge, then press OK. Wait about 10 seconds, then reinstall the battery You can clean the cartridge up to three times. Remove the bright pink tape from the cartridge The battery in the remote may be drained. Turn on the printer. The printer checks for paper in the paper path and will automatically eject the jammed paper. Push down and pull outward on the cartridge in the cradle to remove it. You can browse and print from the camera Image Display or on a television monitor (after connecting the printer to the monitor with the supplied video cable). There may be too much paper loaded in the in-tray. . Check that you are using the correct print cartridge. HP cannot guarantee the quality or reliability of non-HPink 1