Mickley Corporation produces two products, Alpha6s and Zeta7s, which pass through two operations, Sintering and Finishing. Each of the products uses two raw materials-X442 and Y661. The company uses a standard cost system, with the following standards for each product (on a per unit basis): Raw Material Product Alpha6 Zeta7 X442 7661 2.0 kilos 1.5 liters 4.0 kilos 1.0 liters Standard Labor Tine Sintering Finishing 0.30 hours 0.90 hours 0.40 hours 1.00 hours Information relating to materials purchased and materials used in production during May follows: Material X442 1661 Purchases 14,400 kilos 15,400 liters Purchase Cost $ 59,040 $26,100 Standard Price $ 3.90 per kilo $1.00 per liter Used in Production The following additional information is available: a. The company recognizes price variances when materials are purchased. 8,900 kilos 13,400 liters b. The standard labor rate is $20.00 per hour in Sintering and $19.00 per hour in Finishing. c. During May, 1,200 direct labor-hours were worked in Sintering at a total labor cost of $27,480, and 2,890 direct labor-hours were worked in Finishing at a total labor cost of $60,690 d. Production during May was 1,900 Alpha6s and 1,300 Zeta7s. Required: 1. Complete the standard cost card for each product, showing the standard cost of direct materials and direct labor. 2. Compute the materials price and quantity variances for each material. 3. Compute the labor rate and efficiency variances for each operation Complete this question by entering your answers in the tabs below. Req 1 Req 21 Req 3 Complete the standard cost card for each product, showing the standard cost of direct materials and direct labor. (Round your answers in 3 darimal nlaces