Mickley Corporation produces two products, Alpha6s and Zeta7s, which pass through two operations, Sintering and Finishing. Each of the products uses two raw materials-X442 and Y661. The company uses a standard cost system, with the following standards for each product (on a per unit basis): Standard Labor Time Raw Material Product Alpha6 Zeta7 X442 2.5 kilos 4.5 kilos Y661 2.5 liters 4.0 liters Sintering 0.20 hours Finishing 0.40 hours 0.80 hours 1.20 hours Information relating to materials purchased and materials used in production during May follows: Purchase Cost Standard Price $ 3.20 per kilo $ 1.40 per liter Material X442 Y661 Purchases 15,800 kilos 16,800 liters The following additional information is available: $53,720 $21,840 Used in Production 10,300 kilos 14,800 liters a. The company recognizes price variances when materials are purchased. b. The standard labor rate is $23.00 per hour in Sintering and $22.00 per hour in Finishing. c. During May, 1,380 direct labor-hours were worked in Sintering at a total labor cost of $34,500, and 3,030 direct labor-hours were worked in Finishing at a total labor cost of $72,720. d. Production during May was 2,400 Alpha6s and 1,000 Zeta7s. Required: 1. Complete the standard cost card for each product, showing the standard cost of direct materials and direct labor. 2. Compute the materials price and quantity variances for each material. 3. Compute the labor rate and efficiency variances for each operation. Complete this question by entering your answers in the tabs below. Req 1 Req 2 Req 3 Complete the standard cost card for each product, showing the standard cost of direct materials and direct labor. (Round your answers to 2 decimal places.) Standard Quantity or Hours Standard Price or Rate Standard Cost Alpha6: Direct materials-X442 kilos per kilo Direct materials-Y661 liters per liter Direct labor-Sintering hours per hour