Mickley Corporation produces two products, Alpha6s and Zeta7s, which pass through two operations, Sintering and Finishing. Each of the products uses two raw materials-X442 and Y661. The company uses a standard cost system, with the following standards for each product (on a per unit basis): Raw Material Product Alpha6 Zeta7 X442 2.0 kilos 4.0 kilos 5.0 liters Y661 3.4 liters Standard Labor Time Sintering Finishing 0.20 hours 0.25 hours 0.80 hours 0.90 hours Information relating to materials purchased and materials used in production during May follows: Material X442 Y661 Purchases 15,900 kilos 16,900 liters Purchase Cost $ 55,650 Standard Price Used in Production $ 3.30 per kilo $ 23,660 $ 1.50 per liter 10,400 kilos 15,800 liters The following additional information is available: a. The company recognizes price variances when materials are purchased. b. The standard labor rate is $22.00 per hour in Sintering and $20.50 per hour in Finishing. c. During May, 1,300 direct labor-hours were worked in Sintering at a total labor cost of $31,720, and 3,040 direct labor-hours were worked in Finishing at a total labor cost of $68,400. d. Production during May was 2,500 Alpha6s and 1,400 Zeta7s. Required: 1. Complete the standard cost card for each product, showing the standard cost of direct materials and direct labor. 2. Compute the materials price and quantity variances for each material. 3. Compute the labor rate and efficiency variances for each operation. Complete this question by entering your answers in the tabs below. Req 1 Req 2 Req 3 Compute the materials price and quantity variances for each material. Note: Indicate the effect of each variance by selecting "F" for favorable, "U" for unfavorable, and "None" for no effect (i.e., zero variance). Input all amounts as positive values. Direct Materials Variances-Material X442: Materials price variance Materials quantity variance Direct Materials Variances-Material Y661: Materials price variance Materials quantity variance < Req 1 Req 3 >