Mickley Corporation produces two products, Alpha6s and Zeta7s, which pass through two operations, Sintering and Finishing. Each of the products uses two raw materials-X442 and Y661. The standards for each product (on a per unit basis) are as follows: Standard Labor Time Sintering Raw Material Product Alpha6 Zeta7 X442 Y661 Finishing 2.5 kilos 2.5 liters 4.5 kilos 5.0 liters 0.10 hours 0.30 hours 1.00 hours 1.20 hours Information relating to materials purchased and used in production during May follows: Material X442 Y661 Purchases 15,200 kilos 16,200 liters Purchase Cost $ 42,560 $ 24,300 Standard Price $ 2.60 per kilo $ 1.60 per liter Used in Production 9,700 kilos 14,200 liters The following additional information is available: a. The company recognizes price variances when materials are purchased. b. The standard labor rate is $23.00 per hour in Sintering and $21.00 per hour in Finishing. c. During May, 1,320 direct labor-hours were worked in Sintering at a total labor cost of $31,680, and 2,970 direct labor-hours were worked in Finishing at a total labor cost of $68,310. d. Production during May was 1,800 Alpha6s and 1,200 Zeta7s. Required: 1. Complete the standard cost card for each product, showing the standard cost of direct materials and direct labor. 2. Compute the materials price and quantity variances for each material. 3. Compute the labor rate and efficiency variances for each operation. Complete this question by entering your answers in the tabs below. Required 1 Required 2 Required 3 Compute the materials price and quantity variances for each material. Note: Indicate the effect of each variance by selecting "F" for favorable, "U" for unfavorable, and "None" for no effect (i.e., zero variance). Input all amounts as positive values. Direct Materials Variances-Material X442: Materials price variance Materials quantity variance Direct Materials Variances-Material Y661: Materials price variance Materials quantity variance < Required 1 Required 3 > Complete this question by entering your answers in the tabs below. Required 1 Required 2 Required 3 Compute the labor rate and efficiency variances for each operation. Note: Indicate the effect of each variance by selecting "F" for favorable, "U" for unfavorable, and "None" for no effect (i.e., zero variance). Input all amounts as positive values. Direct Labor Variances-Sintering: Labor rate variance Labor efficiency variance Direct Labor Variances-Finishing: Labor rate variance Labor efficiency variance < Required 2 Required 3 >