Moss manufacturing has just completed a major change in its quality control process. Previously, products had been reviewed by QC inspectors at the end of each major process and the companys 10 QC inspectors were charged as direct labor to the operation or job. In an effort to improve efficiency and quality, a computerized video QC system was purchased for $250,000. The system consists of a minicomputer. 15 video cameras, other peripheral hardware, and software. The new system used cameras stationed by QC engineers at key points in the production process. Each time an operation changes or there is a new operation, the cameras are moved, and a new master picture is loaded into the computer by a QC engineer. The camera takes pictures of the units in process and the computer compares them to the picture of a good unit. Any differences are sent to a QC engineer who removes the bad units and discusses the flaws with the production supervisor. The new system has replaced the 10 QC inspectors with 2 QC engineers. The operating costs of the new QC system, including the salaries of the QC engineers, have been included as factory overhead in calculating the companys plant-wide factory overhead rate which is based on direct labor dollars. The companys president is confused. His vice president of production has told him how efficient the new system is, yet there is a large increase in the factory overhead rate. The computation of the rate before and after automation is shown below. Budgeted OH (before) $1,900,000 (after) $2,100,000 Budgeted DL (before) $1,000,000 (after) $ 700,000 Budgeted OH rate (before)190% (after) 300% Three hundred percent lamented the president. How can we compete with such a high factory overhead rate? Required: 4. Explain in detail how Moss Manufacturing could change its overhead accounting system to eliminate confusion over product costs