Multiple Choices

1. A customer's wireless device is displaying a very low signal strength value. What option can improve this situation?

Answer Choice Group

a.Update the client device.

b,Add another access point (AP).

c.Update the computer program (firmware) of the devices.

d.Delete the Microsoft multipath environment.

2. A client wants to know under which frequencies a wireless network operates using the IEEE 802.11n standard. Which of the frequencies below apply to this particular standard? (Select two) Answer Choice Group a. 2.4MHz b. 2.5MHz c. 5MHz d. 2.4GHz 2.5GHz 5GHz

3. A network administrator needs to install a Wireless Access Point (WAP) in a location where there is no electrical wiring. Which of the following should the administrator use to complete the installation? Answer Choice Group a. Coaxial b. Wireless Bridge c. PoE d. Multimode Fiber

4. After a technician has identified the problem and its impact, what is the next step to take? Answer Choice Group

a. Implement preventative metrics.

b. Establish an action plan to solve the problem.

c. Establish a theory of probable cause.

d. Implement the solution or prioritize if necessary.

5. A customer shares half of a rectangular apartment with another company and wants to set up a secure wireless network. The installed antenna limits the signal to half of your floor. After the analysis, the frequencies and channels of the nearby wireless signals were determined and the configuration changes were made successfully, what is the next step to take to configure the secure wireless network? Answer Choice Group a. Decrease the signal strength on the antenna. b. Change the wireless channel on the access point (AP). c. Change the location of the devices (AP) to hinder the signal. d. Configure encryption on WAPs and clients.

6. Joe, a home user, wants to confine his wireless signal to only the devices in his home. Which of the following options allows you to complete this task? Answer Choice Group a. Decrease the strength of the radio signal. b. MAC filtering c. WEP encryption d. Disable the SSID

7. A client cannot access any resources on the network. Which of the following utilities can a technician use to determine the IP address of the client machine? Answer Choice Group a. ipconfig b. nslookup c. say d. tracert

8. A company installed multiple WAPs (Wireless Access Points) to allow their customers to freely roam the company without losing their wireless connection. However, the end result is the opposite. What can be the probable solution to this situation? Answer Choice Group a. Change the SSID to be unique on each WAP. b. Change the direction of the antennas so that it is unique in each WAP. c. Change the encryption method to be unique on each WAP. d. Change the channel to be unique on each WAP.

9. A consultant is installing new WAP in an office, they are wall-mounted. Which of the following is the best location to install these WAPs for best signal strength and coverage? Answer Choice Group a. On the roof with the antennas positioned to the ground b. Close to the floor with the antennas positioned to the ceiling c. lose to the ceiling, but not on it d. Right next to the modem provided by the ISP company

10. Command used to find out the IP address of a wireless adapter: Answer Choice Group a. NSLOOKUP b. IPCONFIG c. TRACERT d. PING