Given the circuit shown in figure 1 with component values R = 10 kn, C = 1 F and L = 22mH. Voltage sources V = 3 V (DC) and V = 1.732 +j V (AC) with frequency f1 [Hz] which is not yet defined. Assume the circuit has reached steady state (no transients in response). Attempt each of the following tasks before coming to the practical laboratory. V1 C V2 - + L www a) If frequency f is set to 100 Hz, calculated the voltage over the resistor, capacitor, and inductor. Note there are two voltage sources in the circuit. b) If frequency f =is set to 2.5 kHz, calculated the voltage over the resistor, capacitor, and inductor. Note there are two voltage sources in the circuit. c) If we consider the resistor, capacitor and inductor as the load connected to the two voltage sources, at which frequency can the load be considered resistive (two decimal accuracy required)? d) If we consider the resistor, capacitor and inductor as the load connected to the two voltage sources, at which range of frequencies can the load be considered inductive (two decimal accuracy required)? e) If we consider the resistor, capacitor and inductor as the load connected to the two voltage sources, at which range of frequencies can the load be considered capacitive (two decimal accuracy required)?