Northwest Building Products (NBP) manufactures two lumber products from a joint milling process: residential building lumber (RBL) and commercial building lumber (CBL). A standard production run incurs joint costs of $495,000 and results in 88,000 units of RBL and 132,000 units of CBL. Each RBL sells for $10 per unit and each CBL sells for $12 per unit. Required: 1. Assuming that no further processing occurs after the split-off point, how much of the joint costs are allocated to commercial lumber (CBL) on a physical measure method basis? 2. If no further processing occurs after the split-off point, how much of the joint cost is allocated to the residential lumber (RBL) using a sales value at split-off method? 3. Assume that the CBL is not marketable at split-off but must be planed and sized at a cost of $330,000 per production run. During this process, 11,000 units are unavoidably lost and have no value. The remaining units of CBL are salable at $14 per unit. The RBL, although salable immediately at the split-off point, is coated with a tarlike preservative that costs $220,000 per production run. The RBL is then sold for $12 each. Using the net realizable value basis, how much of the completion costs should be assigned to each unit of CBL ? 4. Based on information in requirement 3 , should NBP choose to process RBL beyond split-off? Complete this question by entering your answers in the tabs below. Assuming that no further processing occurs after the split-off point, how much of the joint costs are allocated to commercial lumber (CBL) on a physical measure method basis? (Round intermediate calculations to 2 decimal places and final answer to nearest whole dollar amount.)