only need help on part d thanks

20.33 The SolarWorld manufacturing facility in Portland, Oregon, is the largest producer of silicon-based solar cells in the United States. The manufacturing process begins with the melt crystallization of electronic grade silicon into a cylindrical ingot of polycrystalline silicon. The newly formed silicon ingots must then be cooled before they can be sliced into thin silicon wafers. In the present cooling process, a 30 -cm-diameter by 3 -m-long solid silicon ingot is placed vertically within a flowing air stream as shown in the figure. Air maintained at 27C flows normal to the ingot at a velocity of 0.5m/s. Heat transfer from the ends of the ingot can be neglected. At some point in time during the cooling process, the surface temperature of the wafer is measured to be 860K(587C). Parts (a) through (d) all refer to this condition. a. What is the fluid Reynolds number, Re? b. What is the total cooling rate (Watts) from a single silicon ingot at this time in the cooling process? c. What is the Biot number for the heat-transfer process? d. If the air flow around the ingot is turned off, will the heattransfer process be dominated by natural convection, or will the convective heat-transfer process be limited to Nu=0.30 ? What will be the new cooling rate? e. After what elapsed time does the surface of the silicon ingot reach 860K ? Can lumped-parameter analysis be used? Properties of silicon at 860K:Si=2300kg/m3,Cp,Si=760J/ kgK,kSi=30W/mK. Ti