Only need Req. 3

Mickley Corporation produces two products, Alpha6s and Zeta7s, which pass through two operations, Sintering and Finishing. Each of the products uses two raw materials --X442 and Y661. The company uses a standard cost system, with the following standards for each product (on a per unit basis): Product Alpha 6 Zeta Raw Material X442 4661 3.0 kilos 3.0 liters 5.0 kilos 5.0 liters Standard Labor Time Sintering Finishing 0.30 hours 1.10 hours 0.40 hours 1.20 hours Information relating to materials purchased and materials used in production during May follows: Material X442 Y661 Purchase Purchases Cost 15,300 kilos $44,370 16,300 liters $26,080 Standard Price $2.70 per kilo $1.70 per liter Used in Production 9,800 kilos 14,300 liters The following additional information is available: 3. The company recognizes price variances when materials are purchased, b. The standard labor rate is $23.00 per hour in Sintering and $21.50 per hour in Finishing c. During May, 1,320 direct lobor-hours were worked in Sintering at a total lobor cost of $32,340, and 2,980 direct labor hours were worked in Finishing at a total labor cost of $70,030. d. Production during May was 1,900 Alpho6s and 900 Zeta7s. Required: 1. Complete the standard cost card for each product, showing the standard cost of direct materials and direct labor, 2. Compute the materials price and quantity variances for each material 3. Compute the labor rate and efficiency variances for each operation, Complete this question by entering your answers in the tabs below. worked in Finishing at a total labor cost of $70,030. d. Production during May was 1900 Alpha6s and 900 Zeta7s. Required: 1. Complete the standard cost card for each product, showing the standard cost of direct materials and direct labor. 2. Compute the materials price and quantity variances for each material. 3. Compute the labor rate and efficiency variances for each operation. Complete this question by entering your answers in the tabs below. Reg 1 Reg 2 Req3 Compute the labor rate and efficiency variances for each operation. (Indicate the effect of each variance by selecting "F" for favorable, "U" for unfavorable, and "None" for no effect (.e., zero variance). Input all amounts as positive values.) Direct Labor Variances-Sintering: Labor rate variance Labor efficiency variance Direct Labor Variances-Finishing Labor rate variance Labor efficiency variance