our task is as follows:

(1)Place SN74LS08N (AND gate) on a breadboard;

(2)ConnectIC pin 7 to GND and ICpin 14 to 5 V for IC to get powered;

(3)ConnectGPIO pins to a logic gate, as follows:-connect GPIO pin 16 to IC pin 13,-connect GPIO pin 12 to IC pin 12 and-connect GPIO pin SCLK to IC pin 11.

(4)ConnectLEDs and resisters, as follows:-connect LEDs anode (+) to GPIO 12, 16 and SCLK,-connect LEDs cathode (-) to one end of resisters and-connect the other end of resisters to GND.

(5)Develop a python program to simulate the operation of logic AND gate.You should use the loopto operate the logic gate infinitely.This needs to implement one sequence as follows:

Loop

No LED (A and B) Inindicating 0 and 0

PAUSE (2 seconds)

LED_A ON, LED_B OFF indicating 0 and 1

PAUSE (2 seconds)

LED_B ON, LED_A OFF indicating 1 and 0

PAUSE (2 seconds)

Both LEDs ON Inindicating 1 and 1

PAUSE (2 seconds )