Overall validation of process improvement is done by O A process capability report. Generating a process capability report and performing a hypothesis test O with just a hypothesis test. O By generating a regression analysis on the new process. Next > Perform a control chart on data set B with subgroup size 1. What test, if any, does it fail? O The process does not fail any test and is in control O The process shows special cause variation in that 2 out of 3 points are more than 2 sigmas from center line O The process shows special cause variation in that 1 point is more that 3 sigmas from the center line O The process shows special cause variation in that 8 points in a row are above or below the center line In a Gage R&R, the Test-Retest is performed how? O Equipment and appraiser variation O Same as a regular Gage R&R except with a limited number of parts O Using the same part, place, conditions, gage and operator O Same as a regular Gage R&R except with one operator Next > When validating the measurement system in Control, we O Focus on all the X's O Use historical data and process knowledge O Focus on the critical X's identified in the Improve phase O Only a gage R&R procedure. Next > Which of the following is the best yield estimate to use in driving process improvement? O Classical Yield O Throughput Yield O First Time Yield Benchmark Yield Next >