PART 1 1. Generate a 200 kHz sawtooth wave signal, with amplitude of 1.0 Vp, , as measured on the oscilloscope set to display in dBm. 2. Adjust the oscilloscope to display the fundamental and 4 harmonics of the signal. 3. Sketch the spectral components as vertical lines starting at the noise floor. 4. Label the frequencies and the amplitudes in dBm of the spectral components. 5. Record the oscilloscope settings in the table: Oscilloscope on FFT Oscilloscope Settings: 20 dB/DIV 20b K HZ/DIV 600 8.125 2. 0 6.0