PART B: Equivalent Resistance Set up the apparatus as shown in FIGURE 2.4 and Figure 2.5 using resistor R1, R2 and R3. Close the circuit (switch ON). www R1 R21 R3 FIGURE 2.4 Series Connection ww R1 www R2 www R3 FIGURE 2.5 Parallel Connection 2. 3. 4. 5. Repeat step 2 from Part A (Capture your PhEt Circuit) for both of the series and parallel connection. Now, move the voltmeter and ammeter to measure the readings of voltage, V and current, I for each of the resistor. Calculate R1, R2 and R3 by using Ohm's Law. Record the readings and your calculation in Table 2.2. Next, move the voltmeter and ammeter to measure the readings of voltage, V and current, I of the circuit (total voltage and total current). Record the readings in Table 2.3. Then calculate the equivalent resistance for both series and parallel connection.