Perform each of the following using the Console commands on a Cisco switch and show the screenshot of each task:

a) Demonstrate how to show Running Configuration from one of the switches

b) Show how to Change the speed of at least one port on the switch

c) Demonstrate how to Change the duplex on at least one port on the switch

d) Show the last saved (written) Configuration

e) Show CDP Neighbors

f) Show ? See what other options are available

g) Demonstrate how to Connect the Switch to a second Switch

h) Show CDP Neighbors again and highlight any differences from the previous one in question (e)

i) Show Turn Spanning tree on with fast to port

j) Explain what spanning tree is and how fast to port interacts with it

k) Down at least one port on the switch

l) Show how to Bring the port back on-line

m) Demonstrate how to Configure the IP address for the switch

Modes:

Enable

Config T