Peters, Inc. produces 3 products: P1, Q2, and R3. P1 requires 400 purchase orders, Q2 requires 600 purchase orders, and R3 requires 1000 purchase orders. Peters has identified an ordering and r for which the cost driver is purchase orders. Direct labor hours used on each product are 50000 for P1, 40000 for Q2, and 110000 for R3. How much ordering and receiving overhead is assigned to each product? O s66000 O $74250 $110000 $82500 $99000 $82500 $110000 $66000 $165000 $173250 $110000 $181500 u wou of 327 PM 2n2019 Multiple Choice Question 91 . machining ($375000 ), and packing ($160000). The setup department performs 10 setups per year, the machining department works 5000 hours per year, and the packing department packs 500 orders per year Information about Foxx's two products is as follows ProductA1 Product Number of setups Machining hours Orders packed Number of products manufacturesd 1000 150 4000 350 400 If machining hours are used as a base under traditional casting, how much overhead is assigned to Product Al each year? s187500 O $169500 O $282500 O $11300o Open Show Work Click if you would like to Show Work for this question: Question Attempts: 0 of 1 used SAVE FOR LATER SUBMIT ANSWER A Division of 2 327 PM earch Multiple Choice Question 147 Gant Accounting performs two types of s Information on the two services is Direct labor cost CPU minutes $50000 $100000 40000 10000 800 200 and 1 legal hour was used. What is the total cost of Gant Accounting performs tax services for Cathy Lane. Direct labor cost is $1200; 600 cPU minutes were the Lane job using activity-based costing? O $5097 $3897 Qpen Show Work Click if you would like to Show Work for this question: SAVE FOR LATER Question Attempts: 0 of 1 used 328 PM 2/11/2019 arch