please show me your LabView block diagram and front panel and if you could explain how you got it. I can seem to get this to work and I wanna trouble shoot my version.

PURPOSE Construct a LabVIEW program that creates a 1-D array displayed progressively element by element in the front panel. The total number of elements of the array must be entered first by the user in a numeric control box before running the program. The content values of the elements of the array are as follows: The first element should have a value " 1 ", the second element should have a value "2". Then, every other element should contain a value that is the summation of the content values of the previous two elements. As every new element value is calculated, that element is displayed on the front panel every second and the process continues until completing the number of elements previously entered by the user. Then the program should stop. The number of elements could be any number. The front panel should have one "Start" button and one "Stop" button. When running, the program should first wait for the user to press the "Start" button. Once the "Start" button is pressed, the program should build the array element by element, one element at a time every second, until completed. If the "Stop" button is not pressed, the entire array should build to the end. However, the "Stop" button could be pressed any time to stop the program leaving the array only partially built. Front panel at the beginning of the program immediately after pressing the "Start" button: Front panel just before the program finishes if the "Stop" button is not pressed: No. of elements Upload the .vi file (LabVIEW file) to the drop box named "HW2". Once your program is running well in the LabVIEW 2022 version, make sure you save a separate file in the 2016 previous version. The version that you need to upload to the drop box and also run in class is the 2016 version