Answered step by step
Verified Expert Solution
Question
1 Approved Answer
Please solve PHYSICS 111 Experiment # Conservation of Energy Name: Grade: Instructor: Partners: Date Performed: Comments: Date Submitted: OBJECTIVE Conservation of energywill be demonstrated in
Please solve
PHYSICS 111 Experiment # Conservation of Energy Name: Grade: Instructor: Partners: Date Performed: Comments: Date Submitted: OBJECTIVE Conservation of energywill be demonstrated in this lab by comparing the potential energy lost by a falling mass to the potential energy gained by a spring to which the mass is attached. EQUIPMENT Meter stick & masking tape Hooked Masses Set Spring support & stand Spring o All this will be found in the following site: https://phet.colorado.edu/sims/html/masses-and-springs/latest/masses-and-springs_en.html INTRODUCTION The law of conservation of energy is one of the most important principles of Physics. Itrequires that in energy transformations (for a closed system), it is possible to account for all energy gains and losses. Lifting a mass to some height requires a force through a distance (W=Fs). In other words, work must be done on the mass. At its new height, the masshasan increase in its potential energy (P.E.=mgh). To stretch a spring, a force must be exerted through a distance. The stretched spring then has gained a potential energy equal to the work done to stretch the spring (W=Fs). To calculate this work, the average force between two points of stretch for the spring must be used. The average force is the middle force, or the initial force plus the final force divided by two. This occurs because of Hooke's Law, which states that the stretch of a material such as that used in a spring and the force to stretch a spring are uniform and proportional over a range of values. Average force (F/2) times the distance (s) then is Fs/2, or work, which is the area under a force-distance eraph. The energy for the fallen mass can then be comparedto the energy of the stretched spring found from the area under the spring's force-distance graph. PROCEDURE 1. Suspend the spring from the support stand. 2. Locate a zero position or reference position for the spring in the unstretched position. Use the same point of reference for all following measurements. (The very bottom of the spring should serve as a consistent reference point.) Record the zero position here 3. Hanga50gmasson ass the spring. Determine 8 the new position of the reference point and record that in Table I in the column \"Reading on the ruler.\" The clongation is the difference between this value and the zero position of the unstretched spring, as determined in step 2. 2 Convert the masses to ' forces and enter the force and distance values in Table I below. Pl ] 4. Repeat step 3 using 100g, 150g, 200g, and 250g masses. 5. Plot the force and elongation values from Table I on a graph with the elongation as the Calculations: independent variable. The area under the curve represents the work done to stretch the spring 1. Calculate the potential energy lost by the falling mass using the data from table II. Do (Fs/2). not forget the correct units for this calculation. 6. Put a 250g mass on the unstretched spring and allow it to fall. Record the lowest point to which the mass falls. Perform several trials to determine the lowest point with fair 2. Find the energy gained by the stretched spring at the distance of the fallen mass. This certainty. Average these trials in Table II. energy is the area under the graph up to the distance stretched for the fallen mass. It will be necessary to extrapolate the graph to include this point. (Note: For small masses, the 7. Determine and record below the distance through which the mass fell in stretching the spring is not linear. However, this non-linearity near zero may be ignored when finding spring. (DO NOT USE THESE TABLES), they are just a sample of what you should do the area by assuming a straight line for the triangular area under the curve.) Show this in Excel. calculation. 3. Calculate the energy gained by the spring by using data from table I and compare this value with the one obtained in #1 4. Compare the values of the energies from #1, #2 and #3. Table I Table II Questions: Mass Force Ruler Elongation 1. Does the work found as the area under the graph equal the loss in potential energy of (kg) (N) Reading (m) (m the falling mass? What happened to the work done on the spring by the falling mass? Trial # Distance Fallen 2. Explain how this experiment demonstrates conservation of energy. 2 3 AverageStep by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started