Answered step by step
Verified Expert Solution
Question
1 Approved Answer
Power Supply Digital Multi-meter Vcc +12 V Procedure Part 1- Simple Switch Circuit R 1 K Red LED Step 1.1 - Set the DMM
Power Supply Digital Multi-meter Vcc +12 V Procedure Part 1- Simple Switch Circuit R 1 K Red LED Step 1.1 - Set the DMM to measure the resistance. Measure R1 and R2 resistance and enter the values in Result Sheet (T5.1) R 10 K Rp Vout ww Q Step 1.2 Set the power supply to 12 V. Construct the circuit shown in Figure 5.1. Make sure the Power supply is OFF. Pay attention to the direction of the LED. Set the DMM to measure DC Voltage. 10 K 2N3904 3 Vin Figure 5.1 Step1.3 Turn on the Supply and twist the potentiometer's knob all the way so LED becomes OFF. Step 1.4 Set the DMM to measure DC Voltage. Measure the voltage Vin (as indicated in the figure above) and enter the values in Col1, T5.2. Step 1.4 Measure the voltage VOUT (=VCE) and voltage across R2 (VR2 Jenter the values in Col3and Col5of T5.2. Step 1.5 Calculate the Ic and write it down in Col7, T5.2. VR2 Ic = R
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started