Predetermined overhead rate: Budgeted overhead Budgeted direct-labor hours =$3,570,00021,000 hours =$170 per hour For the past 10 years, the company's pricing formula has been to set each product's target price at 110 percent of its full product cost. Recently, however, the standard-model motor has come under increasing price pressure from offshore competitors. The result was that the price on the standard model has been lowered to $110. The company president recently asked the controller, "Why can't we compete with these other companies? They're selling motors just like our standard model for \$106. That's only a buck more than our production cost. Are we really that inefficient? What gives?" The controller responded by saying, "I think this is due to an outmoded product-costing system. As you may remember, I raised a red flag about our system when I came on board last year. But the decision was to keep our current system in place. In my judgment, our product-costing system is distorting our product costs. Let me run a few numbers to demonstrate what I mean." Getting the president's go-ahead, the controller compiled the basic data needed to implement an activity-based costing system. These data are displayed in the following table. The percentages are the proportion of each cost driver consumed by each product line. Case 5-68 (Static) Part 1 Traditional versus Activity-Based Costing Systems (LO 5-1, 5-2, 5-3, 5-4, Required: 1. Compute the target prices for the three models, based on the traditional, volume-based product-costing system. 2. Compute new product costs for the three products, based on the new data collected by the controller. 3. Calculate a new target price for the three products, based on the activity-based costing system. Note: For all requirements, round your intermediate calculations and final answers to 2 decimal places. Required information Case 5-68,69,70 (Static) Use the following information for the Cases below. [The following information applies to the questions displayed below.] Morelli Electric Motor Corporation manufactures electric motors for commercial use. The company produces three models, designated as standard, deluxe, and heavy-duty. The company uses a job-order cost-accounting system with manufacturing overhead applied on the basis of direct-labor hours. The system has been in place with little change for 25 years. Product costs and annual sales data are as follows: *The calculation of the predetermined overhead rate is as follows