probe in the center of the coil and face north, the tare button on the sensor was pressed to zerc was closely followed by clicking \"zero sensor now" in the rotary motion sensor property secti the data sumInanv tab in the program. i-Vith the system calibrated, the DC voltage in output 1 signal generator tab was set to 5 V and we switched from off to auto. With the computer and sensor configured. we placed the magnetic probe as far into the center solenoid as possible and clicked record. Slowly removing The probe from the solenoid, and ks the handle facing north. we pulled the probe out of the solenoid until the sensor was approxima cm above the coil. W'e clicked stop and recorded the current value given. The curve produced procedure should be centered around 0 cm, with an acceptable deviation of less than 3 cm. Tl run is renamed "Center" and the peak amplitude with located using the coordinate tool with a significant figure of 5. These steps are then repeated for three more runs: "East", "West", and Reversed" with specific conditions for how the magnet is removed from the solenoid. In the ' Reversed" portion of the experiment, the plug giving the charge are reversed before the experi conducted