Productivity Measurement, Technical and Allocative Efficiency, Partial Measures Carsen Company produces handcrafted pottery that uses two inputs: materials and labor. During the past quarter, 23,000 units were produced, requiring 92,000 pounds of materials and 46,000 hours of labor. An engineering efficiency study commissioned by the local university revealed that Carsen can produce the same 23,000 units of output using either of the following two combinations of inputs: F1 F2 Combinations: Materials 80,000 30,000 82,200 34,000 Labor The cost of materials is $10 per pound; the cost of labor is $15 per hour. Required: 1. Compute the output-input ratio for each input of Combination F1. If required, round your answers to two decimal places. Materials Labor Does this represent a productivity improvement over the current use of inputs? Yes What is the total dollar value of the improvement? Classify this as a technical or an allocative efficiency improvement. 2. Compute the output-input ratio for each input of Combination F2. If required, round your answers to two decimal places. Materials Labor Does this represent a productivity improvement over the current use of inputs? Now, compare these ratios to those of Combination F1. What has happened? F2 has productivity for materials and productivity for labor. 3. Compute the cost of producing 23,000 units of output using Combination F1. Compare this cost to the cost using Combination F2. Cost of Combination F1 Cost of Combination F2 Difference Does moving from Combination F1 to Combination F2 represent a productivity improvement