Project Report Taslt Dd - Spring support In the previous project task, you have estimated the weight of the hy-pass pipeline. The next step ls devoted to the project of the support itself. The engineering team has decided to deploy a variable spring support on each anchorage point from task 3. A spring, having a free length of 40? mm and a solid length [this latter Identies the length of a spring when It Is fully compressed] of 136 mm, Is to be used. The initially selected spring has a constant k = 21.1 Itgfy'cm, but it can be replaced, if needed. 1. For one support, calculate the lengdt of the spring with the pipeline installed on it. 2. Given that the hy-pass line will also transport hot water, and knowing that the heated up pipeline displaces 2 cm vertically, determine the new lead on the spring, after it has been relieved by this displacement. 3. Knowing that the relieved load ls transmitted to the neighbouring supports, and that the American Petroleum Institute API 5m Standard recommends a maximum of 12% of the load to be transferred, determine If preoompression {a.lt.a. pre-load] should he applied on the spring, for complianoe with the standard. 4. The laypass pipeline is connected to a pump operating at 296:] rpm. Check If the spring of the pipe support is adequate for this condition. If not, recommend a value. 5. Using the APPLET, demonstrate the effect of introducing damping Into the system {play with the applet varying the value of the damping constant \"c\"? and include an explanation, in your report, ofthe effect of damping on the frequency of the system and on Its amplitude