Project Statement: Please design a microstrip broadband matching circuit using any of the tech- niques we discussed in class or covered in the textbook. Simulation result is enough, but if fabrication and measurement is done, extra bonus of 50 points will be added to your project. If prototype is fabricated at the makerspace), please contact me to get the device measured in the lab. The reqpirements are as follows: The broadband matching circuit matches a 300 ohm load to a 50 ohm source over the frequency range of 1 GHz to 4GHz, with the center frequency of 2.5 GHz The maximum in-band reflection coefficient magnitude (ri) should be less than 0.1 (or -20 dB). The in-band insertion loss should be less than 0.5 dB. The metallic material is copper. The substrate is FR4, with the permittivity of er = 4.4, the loss tangent of tan 8 = 0.02 and the height of 1.5mm Project Statement: Please design a microstrip broadband matching circuit using any of the tech- niques we discussed in class or covered in the textbook. Simulation result is enough, but if fabrication and measurement is done, extra bonus of 50 points will be added to your project. If prototype is fabricated at the makerspace), please contact me to get the device measured in the lab. The reqpirements are as follows: The broadband matching circuit matches a 300 ohm load to a 50 ohm source over the frequency range of 1 GHz to 4GHz, with the center frequency of 2.5 GHz The maximum in-band reflection coefficient magnitude (ri) should be less than 0.1 (or -20 dB). The in-band insertion loss should be less than 0.5 dB. The metallic material is copper. The substrate is FR4, with the permittivity of er = 4.4, the loss tangent of tan 8 = 0.02 and the height of 1.5mm