Question 1 1 pts You see the following trace on your oscilloscope screen: what is the voltage amplitude of the signal you are measuring in mV? RIGOL T' D 150.0my Time 10.80us 7:2.800usQuestion 2 1 pts What is the uncertainty in the amplitude of the signal shown on the scope trace above {answer in mV]? Question 3 1 pts What is the period (in us) of the waveform shown in the scope trace above? Question 4 1 pts The waveform you are trying to measure appears to be running across the screen from left to right orjittering back and forth so you can't line it up with the graticule. You should (select the best answer): 0 change the horizontal scale 0 change the coupling from AC to DC 0 make sure the signal is triggered by checking which channel is used for triggering and adjusting the trigger level 0 all of the above: try everything until it works Question 5 1 pts You are measuring the resistance of a resistor with a DMM but the last digit is uctuating. Your partner insists that you should take the most commonly displayed value and half the last digit for the uncertainty. What do you say to your partner? 0 Yes. I agree. The uncertainty in a digital reading is hallc the smallest shown digit, and the most common value is the most representative reading. so I agree. 0 No, the uncertainty is fine, but we have to take the average of several measurements to nd the best value. 0 No, we can take the most common value displayed or the average of several readings, but in either case, the uncertainty should include any uctuations in the reading so we should take half the range between the max and min values you see while trying to measure as the uncertainty. Question 6 1 pts What is the voltage across the 1000 resistor with a 5V battery connected to the power rails (answer in V)? 5V . . . . . 5 MM R= 100M 20 25 30Question 7 1 pts Where should you move the pink-circled end of the wire (currently in g-13) to close the circuit? (Select all that are correct) 5V abcde . . . 5 R = 1005 15Of-12 Oh-11 0 g-11 Of-10 O e-11 g-13; it is fine where it isQuestion 8 1 pts Where would you place the two ends of a voltage probe to connect to a digital multimeter or oscilloscope to measure the voltage across the pink 502 resistor in this circuit? (Select all that are correct) 5V abc de g 1 1 . . . R= 10052 R= 5012 15 20i-11 and i-15 red power rail 11 and blue power rail 15 h-10 and h-16 e-11 and g-15 g-11 and i-15Question 9 1 pts In the above breadboard image, what would the voltage be across the 500 (pink) resistor (answer in V)