Question 2: In Figure 2. you may create your own address assignment to the networks connected to Router X (Note: you do not need to do it for all network in the Figure, just for the ones next to Router X). Assume you are allocated addresses in the 10.10.10.0/24 range. Write down the complete CLI commands, with all the details of the addresses and interfaces: Area 2 Stub Area 1 Area 3 Router Y RIP Network Router X Router Z ASC Area 0 AS A Figure 2 - OSPF network with multiple areas. 1) to configure the Ethernet interface on Router X 2) to configure the two Serial interfaces on Router X 3) to configure OSPF in Router X. 4) From the figure, is the RIP network in the same Autonomous System as router X? Why (not)? Please explain in detail. Question 2: In Figure 2. you may create your own address assignment to the networks connected to Router X (Note: you do not need to do it for all network in the Figure, just for the ones next to Router X). Assume you are allocated addresses in the 10.10.10.0/24 range. Write down the complete CLI commands, with all the details of the addresses and interfaces: Area 2 Stub Area 1 Area 3 Router Y RIP Network Router X Router Z ASC Area 0 AS A Figure 2 - OSPF network with multiple areas. 1) to configure the Ethernet interface on Router X 2) to configure the two Serial interfaces on Router X 3) to configure OSPF in Router X. 4) From the figure, is the RIP network in the same Autonomous System as router X? Why (not)? Please explain in detail