Answered step by step
Verified Expert Solution
Question
1 Approved Answer
Question 27 3 pts A manufacturer of plastic components inspects the product and finds that the exterior dimension of the parts is slightly out of
Question 27 3 pts A manufacturer of plastic components inspects the product and finds that the exterior dimension of the parts is slightly out of tolerance. They contact the customer to see if they will take them anyway. The customer takes them but negotiates a reduced price. This handling of nonconforming parts is known as O Scrap O Rework O Repair O Regrade O ConcessionD Question 28 3 pts The amount that a part characteristic can vary and still be considered suitable for use is given by the O Nominal value O Acceptable defect rate Process allowance O Specification limitsQuestion 29 3 pts Reliability analysis of many aeronautical systems components is often performed using the lognormal distribution. If the number of cycles of use before failure of a component follows a lognormal distribution with parameters u= 14 and o = 4.6. What is the probability that the component will fail in less than 1400 cycles? O 0.036 O 0.071 O 0.062 O 0.231Question 30 3 pts A probability plot was created for a data set. Assuming the data is normally distributed and the line represents the population from which the data came from, below approximately what value would 10% of the observations from the population fall? 99.9 99 95 90 Percent 10 195 Percent 10 0.1 5.0 7.5 10.0 12.5 15.0 O 10.1 O 8.2 07.5 6.5
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started