Question 3 1 pts

(TCO 1) Name one advantage of modular switches over fixed-configuration switches.

Easier management of switched network

Increased throughput

Fewer data drops

Easier to remove port aggregation

Increased delay

Flag this Question

Question 4 1 pts

(TCO 1) Name one disadvantage of fixed-configuration switches over modular switches.

Ease of management

Port security

Fewer high-speed ports

Easier to add additional ports

Increased delay

Flag this Question

Question 5 1 pts

(TCO 1) Name one disadvantage of the cut-through switching method as opposed to the store-and-forward switching method.

Fast forwarding decision

Erroneous frame delivery

Increased latency

Slow frame delivery

Increased frame overhead

Flag this Question

Question 6 1 pts

(TCO 1) A switch receives a frame from PC-A to PC-B. Both PCs are on the same VLAN. The MAC Address of PC-A is not yet registered in the switch MAC Address Table. Where will the switch forward the frame?

To all active ports in the VLAN except for the ingress port

Directly to PC-B if the switch knows the source MAC Address

Floods the frame to all ports assuming PC-Bs Physical Address is in the Switch MAC Address Table

A and C

None of the above

Flag this Question

Question 7 1 pts

(TCO 1) Which action does not occur before the boot loader initializes the CPU?

Boot loader executes POST

Switch loads boot loader software

A and B

Firmware in POST checks the BIOS before loading it in memory

All of the above

Flag this Question

Question 8 1 pts

(TCO 1) Which step is not appropriate to recover from a damaged operating system?

Boot loader prompt switch: will appear.

Press mode button until System LED turns briefly amber.

Type recover IOS from Switch prompt

Unplug the switch power cord.

B and C

Flag this Question

Question 9 2 pts

(TCO 1) A network engineer observes that the Port LED lights are off on one of the network switches. What does this indicate?

The ports are disabled in software.

There is a link fault.

There may have been too many collisions before the switch turns off the ports.

The ports may not be receiving enough power.

None of the above

Flag this Question

Question 10 2 pts

(TCO 1) The IP address configured on a switch must be assigned

to the main VLAN interface on a switch.

to the physical interface on the main port on the switch.

A and B

to the physical interface of VLAN 1.

None of the above

Flag this Question

Question 11 2 pts

(TCO 1) The following command turns off dynamic port on a Cisco switch.

Switchport mode access

Switchport access VLAN

Switchport dynamic off

Switchport port-security off

None of the above

Flag this Question

Question 12 2 pts

(TCO 1) The following command turns off dynamic port on a Cisco switch.

Interface duplex mode full

Set duplex mode full

Duplex mode full

Configure duplex mode full

Duplex full