Question: The transfer functions of a long end mill attached to the spindle are measured at 2 points in both feed X and normal Y directions (see the Figure). The accelerometer was attached to point 1, and the hammer instrumented with an impact force sensor is applied to two points. The measured transfer functions are curve fitted with modal analysis software, and the modal parameters are given in the Table. a) Identify the real modal matrix in both X and Y directions. b) Plot the mode shapes in X direction. c) Evaluate and plot the direct transfer function at point 2 in directions X and Y. (i.e. hx22, hy22=?). @On [Hz] S r=0+j V [s/kg] 12=02+j V2 [s/kg] Mode 1 354.3 0.038 Table: Transfer function parameters X Direction -6 1.9890-10 -j 1.9644-10-5 -4.4952-10-6 -j 1.2556-10-5 Mode 2 467.6 0.049 1.4978-10-5 -j 4.4070-10-5 7.0287-10-6 -j 3.3470-10-5 Accelerometer. 127 mm Tool Holder Tool 20 13 mm Mode 1 225.6 0.038 8.5993-10-6 -j 1.5280-10-5 4.0081-10-6 -j 1.0945-10-5 25 mm -X Y Direction Hammer 75 mm Mode 2 386.6 0.035 1.4732-10-5 -j 4.9648-10-5 4.4653.10-6 -j 3.3297.10-5