Questions are in the picture

REVISIONS 011 A HOLES IN EACH PT 11- 1.00 X 15" CHAMFER BOTTOM OF PIS INS -750-10 UNC-2B IN PT 10 ONLY 02 06 HOLES IN PTA & L 11 FOR PT 1 12 DO 36 X 45 CHAMFER ON PT 4 QUESTIONOU 1 How many 01.91 holes are there in the complete assembly? . How deep is the .750 tapped hole? 3. What was the original size of the 01.31 hole? 4. What is the overall height of the assembly? centre line of the assembly 4. Determine distance XL 7. What is the developed width of part ?? U Inside dimensions of channel. A. What is the clearance for fitting on the length B. What is the length of (A) pt. 2. (B) pt. 4. allow 25 for clearance. (C) pt. 7. (D) PL. 37 10. What is the difference between pl. 4 and pl. 57 11. How many 1.00 chamfers are needed? 12. What does G maan on 50 bevel weld symbols" 13. What type of weld is used to faster pt. 11 00 14. What type of weld is used to join pt. 3 la pl. 2 at the sides? 15. How many parts make up the skid assembly? 16. Complete the missing sizes in the bill of material. Use inside travel for calculating pl. 2. NOTE UNLESS OTHERWISE SPECHEJ TOLERANCE ON LINEAR DIMENSIONS H ON ANGLES 05. - THREAD CONTROLLING ORGANIZATION AND STANDARD ASME 01.1-2003 ASSIGNMENTI RIGHT- VILW ARRANGEMENT OF VIEWS ON A ONE INCH GRID SHEET (10-IN. SQUARES), SKETCH SECTION VIEWS AT A A AND B E AND AN ENLARGED VIEW AT VIEW C. SHOW ONLY THE PARTS AND THE WELDS. SCALE 1:1 LOCATING ANGLE STL 800X400X 50XAXLE 11 SON D3.00 STLAD| 2 GAOUNDAR FILTAINER DRAW BAR ST. CAR | TLX 300K 1" 25 QUBOET ENG PLATE BARE ||||||SKID ABOY 50 X 100 X 25.90 SON DESCRIPTION