Refer to Table S6.1 - Factors for Computing Control Chart Limits (3 sigma) for this problem Sampling 4 pieces of precision-cut wire (to be used in computer assembly) every hour for the past 24 hours has produced the following results Hourx Hourx R Hour x R Hour 3.35"0.71"73.15" 0.48"13 3.21" 0.80" 19 3.00 1.23 3.12 1.48 3.31" 1.56" 2.79 1.14 92.92 0.76 15 3.22 1.1 21 2.55 1.08 4 3.39 1.3 10 2.75 1.33 16 2.94 0.50 22 3.28 0.46 53.17 1.2211 2.83 1.12 17 2.96 1.38 233.04 1.63 2.54 0.92 8 2.55 1.08 14 2.73 1.31 20 6 2.76 0.37 12 2.97 0.4018 2.64 1.24 24 Based on the sampling done, the control limits or 3 sigma x chart are round a intermediate calculations to three decimal places before proceeding with further calculations) Upper Control Limit (UCLz) = 3.739 inches (round your response to three dec mal places, Lower Control Limit (LCL 2.225 inches (round your response to three decimal places) Based on the x-chart, the wire cutting process has been IN CONTROL The control limits for the 3-sigma R-chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCLR) = 2.369 inches (round your response to three decimal places). Lower Control Limit (LCLR) = 0.000 inches (round your response to three decimal places) Based on the R-chart, the wire cutting process has been IN CONTROL Sample Mean Factor, Size, n Upper Range, Lower Range, 3 1.880 1.023 0.729 0.577 0.483 0.419 0.373 0.337 0.308 0.266 3.268 2.574 2.282 2.115 2.004 1.924 1.864 1.816 5 0.076 0.136 0.184 0.223 0.284 10 12 1.716