Refer to Table S6.1 - Factors for Computing Control Chart Limits ( 3 sigma) for this problem. Sampling 4 pieces of precision-cut wire (to be used in computer assembly) every hour for the past 24 hours has produced the following results: Based on the sampling done, the control limits for 3 -sigma x chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL)=inches (round your response to three decimal places). Based on the sampling done, the control limits for 3 -sigme x chart are (round all intermediate calculations to three decimal places before proceeding with further caiculations): Upper Control Limit (UCL-: ) ) = inches (round your response to three decimal places). Lower Control Limit (LCL)= inches (round your rosponse fo three decimal places). Based on the x-chart, the wire cutting process has been The control limits for the 3-sigma R-chart are (round al intem reimal places before proceeding with further calculations): Upper Control Limit (UCLR)= inches ( round your res 1. Based on the R-chart, the wire cutting process has been