Refer to Table S6.1 - Factors for Computing Control Chart Limits (3 sigma) for this problem. Sampling 4 pieces of precision-cut wire (to be used in computer assembly) every hour for the past 24 hours has produced the following results: Based on the sampling done, the control limits for 3-sigma x chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Based on the sampling done, the control limits for 3 -sigma x chart are (round al intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCL)=inches (round your response to three decimal places). Lower Control Limit (LCLx)= inches (round your response to three decimal places). Based on the x-chart, the wire cutting process has been The control limits for the 3-sigma R-chart are (round all intem mal places before proceeding with further calculations): Upper Control Limit (UCLR)= inches (round your res Lower Control Limit (LCLR)= inches (round your res) Based on the R-chart, the wire cutting process has been The control limits for the 3-sigma R-chart are (round all intermediate calculations to three decimal places before proceeding with further calculations): Upper Control Limit (UCLR)= inches (round your response to three decimal places). Lower Control Limit (LCLR)= inches (round your response to three decimal places). Based on the R-chart, the wire cutting process has been