Required information [The following information applies to the questions displayed below.] Sweeten Company had no jobs in progress at the beginning of the year and no beginning inventories. It started, completed, and sold only two jobs during the year-Job P and Job Q. The company uses a plantwide predetermined overhead rate based on machine-hours. At the beginning of the year, it estimated that 4,000 machine-hours would be required for the period's estimated level of production. Sweeten also estimated $29,800 of fixed manufacturing overhead cost for the coming period and variable manufacturing overhead of $2.90 per machine-hour. Because Sweeten has two manufacturing departments-Molding and Fabricationit is considering replacing its plantwide overhead rate with departmental rates that would also be based on machine-hours. The company gathered the following additional information to enable calculating departmental overhead rates: Estimated total machine-hours used Estimated total fixed manufacturing overhead Molding 2,500 Fabrication 1,500 Total 4,000 Estimated variable manufacturing overhead per machine-hour $ 13,000 $ 2.60 $ 16,800 $ 3.40 $ 29,800 The direct materials cost, direct labor cost, and machine-hours used for Jobs P and Q are as follows: Direct materials Direct labor cost Actual machine-hours used: Molding Total Fabrication Job P $ 25,000 $ 30,600 Job Q $ 14,000 $ 12,300 2,900 2,000 1,800 4,700 2,100 4,100 Sweeten Company had no overapplied or underapplied manufacturing overhead costs during the year. Required: For questions 1-8, assume that Sweeten Company uses a plantwide predetermined overhead rate with machine-hours as the allocation base. For questions, 9-15, assume that the company uses predetermined departmental overhead rates with machine-hours as the allocation base in both departments. 10. How much manufacturing overhead was applied from the Molding Department to Job P and how much was applied to Job Q? Note: Do not round intermediate calculations. Job P Job Q Manufacturing overhead applied