Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

Set your oscilloscope to display the frequency spectrum of the input: Press the Auto-Scale button and acquire in High Resolution mode. Set the time/div to

Set your oscilloscope to display the frequency spectrum of the input: Press the Auto-Scale button and acquire in High Resolution mode. Set the time/div to 1 ms, the Volt/div to 500 mV, and adjust the Oset, so that the time domain signal stays in the top part of the display. Remember that the time domain signal has to be completely inside the scope display before performing the FFT. To synchronize the scope with the AM signal you can rise the threshold level of the trigger to about 450 mV. Press FFT button. Inside More FFT press the Auto-Setup button. Set the center frequency to 14 kHz and the frequency span to 20 kHz. Set the Scale to 15 dB/div (You need to turn on the Fine scaling by pressing once the Scale knob) and adjust the Oset so that the frequency spectrum stays in the bottom of the display, without interfering with the time domain.. 4. Sketch both, the time domain AM signal and its frequency spectrum and explain what you see in terms of the modulation property of the Fourier transform. (Hint: What is the frequency spectrum of the message signal (co- sinusoid of

Step by Step Solution

There are 3 Steps involved in it

Step: 1

blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image_2

Step: 3

blur-text-image_3

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Statistical Physics

Authors: Franz Mandl

2nd Edition

0471915335, 9780471915331

More Books

Students also viewed these Physics questions

Question

What is carpal tunnel syndrome?

Answered: 1 week ago