SUBNET 2 Fao SUBNET 1 Server-PT Servero Fa0/2 Gig0/1 Fao Gig0/0 Fa0/1 PC-PT PC1 Fa0/1 Fa0/2 2911 R1 2960-24Fa0/3 Switch 2960-24TT Switch1 Fao PC-PT PCO Below you are asked to practice Equal Size Subnetting and then configure the devices Ri, Switch 0, PCO.PC1, and the Servero. Apply Equal Size subnetting on network 192.168.192.0/23 to create 4 networks. The first network address you get from subnetting will be the Network Address of Subnet 1 and the second network address you get from subnetting will be that of Subnet 2. Relying on the results you got from Part 1 you are asked to configure the below devices as follows: o Router RI o Set the hostname of R1 to be Myrouter. o Give interface GO/O the last valid ip address from Subnet 1. Activate the interface. . Give interface G0/1 the first valid ip address from Subnet 2. Activate the interface. o Set the privileged mode secret to NoAccess. o Save your configurations o Switch 0 o Set the hostname to mySwitch. o Set the console password to Ciscopass. Configure interface Vlan 1 with the second valid ip address in Subnet 2. o Set the appropriate default gateway address. o Set a banner message "Authorized Access Only" o Encrypt all configured passwords. o Save your configurations 0 o Configure PCO with the 3rd valid ip address in Subnet 2, a subnet mask and a default gateway. o Configure PCI with the first valid ip address in Subnet 1, subnet mask and default gateway. o Configure the Server0 with the 10th valid ip address in Subnet 2. a subnet mask, and a default gateway