Suppose that a metal rod is supposed to be cut 51.8mm. in length. The upper spec limit is set at 52.9mm., and the lower spec limit set at 50.7mm. A metal rod that is out of spec must be scrapped at a cost of $31.00. The company uses the Taguchi Quality Loss Function to estimate quality costs. Suppose that a sample of three units was taken, and the rod measurements were: 51.5,51.2, and 49.5mm., respectively. Harry likes the Taguchi Quality Loss function, but he believes that a linear function would better represent the cost of quality. Specifically, Harry prefers a loss function of the form: L=TD, where L,D, and T have the same definitions as in the Taguchi model. What would be the quality cost of the sample of three units using Harry's model? a) The linear Taguchi parameter T is $/mm (round your response to two decimal places). b) The Quality Cost of the first metal rod is $ (round your response to two decimal places). c) The Quality Cost of the second metal rod is $ (round your response to two decimal places). d) The Quality Cost of the third metal rod is $ (round your response to two decimal places). e) What is the total Taguchi-like Quality Cost of that sample of three units? $ (round your response to two decimal places)