Answered step by step
Verified Expert Solution
Question
1 Approved Answer
Task 2 Layer 2 Implementation and Analysis In Subnet A, allocate VLAN 300 for PC-B and PC-C and VLAN 500 for PC-A in the
Task 2 Layer 2 Implementation and Analysis In Subnet A, allocate VLAN 300 for PC-B and PC-C and VLAN 500 for PC-A in the upper left (cyan) quadrant configuring appropriate switch port settings. In the lower left (pink) quadrant of Subnet A, allocate VLAN 500 to PC-D & PC-F and allocate PC-E to VLAN 300 configuring appropriate switch port settings. Appropriately configure the router interface and DHCP pools to accommodate the subnet changes required for the VLAN configuration. (This may either be done with an additional link between SW-C and R-A or by creating a "Router on a Stick" configuration with sub-interfaces on R-A (Note: this has been mentioned, but not covered in the workshops). Check connectivity within the same and different VLANs. Use 'Simulation' mode in Packet Tracer to show the connectivity with 'pinging' using GUI with the router interfaces being en abled and disabled. Analyse the results and explain why it was a 'success' or 'failure'. Your report should document the IP ranges and masks for each subnet and describe your solution for VLAN configuration and routing between subnets and how it differs to task 1.
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started