Task $2$ Network Design and Plan

Use Packet Tracer to construct a network as depicted in Figure $1.$ The IP addresses for each of the subnets,

except for the inter$-$router links, should be allocated using DHCP configured in the routers. You must use a

dynamic routing protocol such as RIP or OSPF: Static routes are a not permitted. Test your solution by using

ping between hosts in the same subnet and between hosts in a different subnet. Your report should

document the IP ranges for each subnet and describe your solution for routing between subnets and why you

chose that solution. Use simulation mode to send a message between T$1$ and R$3.$ Disable the link between

Router North and Router East. Again, use simulation mode to send a message between T$1$ and R$3.$ Describe the

changes in behaviour of your model. Discuss any shortcomings of the network design. Include screenshots of

simulation mode in your report.

Note: the red inter$-$router links are serial connections, whereas the red router to switch connections are optic

fibre links. The network uses the generic PT switches and routers. You may use other model switches or

routers if they support the required links.