Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

thanks for the assistance. I know its a lot 1. A quartz sphere is 15.0 cm in diameter. What will be its change in volume

thanks for the assistance. I know its a lot

image text in transcribedimage text in transcribed
1. A quartz sphere is 15.0 cm in diameter. What will be its change in volume if its temperature is increased by 280 OF? (the coefficient of volume expansion of quartz is 1.50 x 10-6 oc-1) cm 3 2. A concrete highway is built of slabs 19.0 m long (at 18 .C). How wide should the expansion cracks be (at 18 C) between the slabs to prevent buckling if the annual extreme temperatures are -27 .C and 50 .C? (the coefficient of linear expansion of concrete is 1.20 x 10-5 .c-1) meters 3. Concrete sidewalks are always laid in sections, with gaps between each section. For example, the figure shows five identical 5.30-m sections, the outer two of which are against immovable walls. The four identical gaps between the sections are provided so that thermal expansion will not create the thermal stress that could lead to cracks. What is the minimum gap width necessary to account for an increase in temperature of 32 .C? cm Gap 4. A circular piece of diameter 8.40 cm is cut from an aluminum sheet at 18 C. If the sheet is then placed in an oven and heated to 135 C, what will the new area of the hole be?(The coefficient of thermal expansion for aluminum is 2.30 x 10- .c-1) cm2 5. A 755 g piece of copper is heated in a furnace to a temperature T. The copper is then inserted into a 145 g copper calorimeter containing 260 g of water. The initial temperature of the water and calorimeter is 17 .C, and the final temperature after equilibrium is established is 40 C. When the calorimeter and its contents are weighed, 39.0 g of water are found to have evaporated. What was the temperature T?(Cw = 4186 J/(kg. C), Ly=3.35 x 10 J/kg, Ly=2.26 x 10 J/kg, Ccopper = 387 3/(kg. C) .C5. A 755 g piece of copper is heated in a furnace to a temperature 7. The copper is then inserted into a 145 g copper calorimeter containing 260 g of water. The initial temperature of the water and calorimeter is 17 .C, and the final temperature after equilibrium is established is 40 C. When the calorimeter and its contents are weighed, 39.0 g of water are found to have evaporated. What was the temperature T?(cw 4186 J/(kg. C), Lf=3.35 x 10% j/kg, Ly=2.26 x 100 J/kg, Ccopper = 387 J/(kg. C) .C 6. A well-insulated styrofoam bucket contains 149 g of ice at 0 .C. If 21 g of steam at 100 .C is injected into the bucket, what is the final equilibrium temperature of the system?(Cwater=4186 J/kg. C, LF= 3.35 x 10' J/kg, Ly=2.26 x 10' J/kg) .C 7. A cube of ice is taken from the freezer at -14 .C and placed in a 100 g aluminum calorimeter filled with 270 g of water at a temperature of 26 C. The final situation is observed to be all water at 17 .C. What was the mass of the ice cube?(Cwater=4186 J/kg.C, Cal-900 J/kg.C, Cice=2000 J/kg. C, LF=3.35 x 10 3/kg) grams 8. An electric immersion heater has a power rating of 1900 W. If the heater is placed in a 1.3 kg of water at 15 .C, how many minutes will it take to bring the water to a boiling temperature? (Assume that there is no heat loss except to the water itself. Cwater=4186 J/kg.C) min 9. A 44.0-kg block of ice at 0C is sliding on a horizontal surface. The initial speed of the ice is 7.30 m/s and the final speed is 3.20 m/s. Assume that the part of the block that melts has a very small mass and that all the heat generated by kinetic friction goes into the block of ice. Determine the mass of ice that melts into water at 0.C. grams 10. A 0.500-kg of ice is initially at temperature of -8.0 C. How much heat is required to melt one-third the mass of the ice only

Step by Step Solution

There are 3 Steps involved in it

Step: 1

blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image

Step: 3

blur-text-image

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Physics Of The Plasma Universe

Authors: Anthony L Peratt

2nd Edition

1461478197, 9781461478195

More Books

Students also viewed these Physics questions