The diameters of a set of holes and shafts to be mated have been measured and the data are shown below (unit: inches): 1 2 3 4 5 6 7 8 9 10 Shaft 0.992 0.982 0.979 0.986 0.988 0.99 0.987 0.992 0.986 0.968 Hole 1.009 1.011 1.009 1.008 1.011 1.012 1.007 1.016 1.016 1.013 (a) Determine the tolerance of these parts using the unilateral and bilateral notations. For the unilateral specification, use 0 as the lower tolerance limit for the holes and as the upper tolerance limit for the shafts. (b) c) d) Determine the allowance (clearance or interference) of these two parts. The tolerance of an assembled length T, equals (T) + (TB) + ... where T etc. equals the tolerance of the individual parts. What is the tolerance on the assembled length? If the thermal expansion coefficient of this material is 16 106/C, determine how much the hole temperature must be elevated to successfully complete the insertion of all the shafts into the holes without force. Assume the nominal hole diameter is 1 inch. Surface profile measurements were taken from the surface of a machined workpiece. Answer the following questions using the information shown in Figure below and Table 1.