The label (LBL) instruction is: always logically true. has the same address as the jump instruction with which it is used. is used to identify the ladder rung that is the target destination of the JMP instruction. all of these. For the program show, the pilot light will be: on at all times off at all times switched on 15 s after the switch has been actuated from the open to the closed position switched off 15 s after the switch has been actuated from the on to off position A subroutine is a section of program that is not scanned unless there is: a fault a request for the scan to go that particular subroutine. a need to execute a section of the program on a time basis rather than on an event basis a forced input or output condition Which of the following instruction would most likely be programmed outside the jumped area of a program? Latch and unlatch instructions Times and counter instructions Immediate inputs and outputs