the new phone. His du 0.35 hour per unit. A Determine the Assembly activity cost using the S-3 labor classificati Is the product engineer's proposal supported? ADM-3 Production run size and activity improvement Littlejohn, Inc. manufactures machined parts for the automotive industry. The activity associated with Part XX-10 is as follows: Activity Rate = Activity Fabrication Setup Production control Moving Total activity cost per unit Estimated units of production Activity cost per unit Activity Bose Usage 250 dlh 10 setups 10 prod.runs 10 moves $80 per dih $80 per setup $30 per prod. run $25 per move Activity Cost $20,000 800 300 250 $21,350 500 $ 42.70 Chapter 4 Activity-Based Costing 199 Each unit requires 30 minutes of fabrication direct labor. Moreover, Part XX-10 is manufactured in production run sizes of 50 units. Each production run is set up, scheduled (production control), and moved as a batch of 50 units. Management is considering improvements in the setup, production control, and moving activities in order to cut the production run sizes by half. As a result, the number of setups, production runs, and moves will double from 10 to 20. Such improvements are expected to speed the company's ability to respond to customer orders. Setup is reengineered so that it takes 60% of the exiginal cost per setup. Production control software will allow productes control effort and cost per production run to decline by 60%. Moving distance was reduced by 40%, thus reducing the cost per move by the same amount. A. Determine the revised activity cost per unit under the proposed changes. B. Did these improvements reduce the activity cost per unit? c. What cost per unit for setup would be required for the solution in (A) to equal the base solution? ADM-4 Hospital activity-based costing analysis Lancaster County Hospital uses activity based on