The $......$signal of $8086$ is sampled at the end of the second T$-$state of

every bus cycle.

The $.....$is an identification number $($in binary$)$ for memory locations.

The $8086$ instruction $....$disable all the interrupt.

Thi $.$ state is used to keep the device electrically isolated from the

system.

pin of $8086$ is made low by external hardware when the instruction

NOP is executed.

The address line

is used to seleet the even bank of $8086$ memory.

The content of $AL$ register after execution of the $8086$ instruction XOR AL$,$ AL is $-$

signal is used to differentiate the minimum mode or maximum mode

operation in $8086$ processor.

The BIU has

numbers of $16-$bit segment registers.

The instruction of $8086$ is used to find $1\text{'}$s complement of the special

register memory content.

The content of $AL$ register is $80H.$ the value of $Ax$ register after the execution of

CBW instruction of $8086$ is

Transferring different information at different well$-$defined times through the same

lines is called

The ALE is connected to the

pin of the external $8-$bit latches.

flag is used for single step execution in $8086.$