stes) 118. Which of the following statements about sizing equipment grounding conductors for parallel circuits is true? A. When all parallel conductors are installed a common raceway, an equipment grounding conductor must be installed for each set of parallel conductors. B. When parallel conductors are installed in separate cables, a full-size equipment grounding conductor must generally be installed in each cable. determined C. When parallel conductors are installed in separate raceways, the equipment grounding conductor is sized according to the ampacity of the conductors in the raceway. D. The equipment grounding conductor must be sized not smaller than the load rating of the equipment at the termination of the circuit. 119. The minimum size of an equipment grounding conductor for feeder taps is A. based upon the rating of the overcurrent protection at the load end of the feeder tap. 8. based upon the ampacity of the tap conductors from Table 310.15(B)(16). C based upon the ampacity of the feeder to which the tap conductors are connected. D. based upon the rating of the overcurrent protection on the supply side of the feeder conductor. 120. For grounded systems, equipment grounding conductor connections are required to be made in accordance with which of the following statements? A. The equipment grounding conductor is bonded to the grounded service conductor. 8. The equipment grounding conductor is bonded to the grounding electrode conductor. C. The equipment grounding conductor is bonded to the grounded service conductor and the grounding electrode conductor, D. The equipment grounding conductor is routed back to the utility transformer, where it is connected to the neutral.