This is a solar tracker code for arduino. Can you please add a code for an LCD that displays when the solar tracked moves and how many degrees and which side.

the code is at the bottom.

Thank you

#include // include Servo library Servo horizontal; // horizontal servo int servoh = 90; // stand horizontal servo Servo vertical; // vertical servo int servov = 90; // stand vertical servo // LDR pin connections // name = analogpin; int ldrlt = 0; //LDR top left int ldrrt = 1; //LDR top rigt int ldrld = 2; //LDR down left int ldrrd = 3; //ldr down rigt void setup() { Serial.begin(9600); // servo connections // name.attacht(pin); horizontal.attach(9); vertical.attach(10); } void loop() { int lt = analogRead(ldrlt); // top left int rt = analogRead(ldrrt); // top right int ld = analogRead(ldrld); // down left int rd = analogRead(ldrrd); // down rigt int dtime = analogRead(4)/20; // read potentiometers int tol = analogRead(5)/4; int avt = (lt + rt) / 2; // average value top int avd = (ld + rd) / 2; // average value down int avl = (lt + ld) / 2; // average value left int avr = (rt + rd) / 2; // average value right int dvert = avt - avd; // check the diffirence of up and down int dhoriz = avl - avr;// check the diffirence og left and rigt if (-1*tol > dvert || dvert > tol) // check if the diffirence is in the tolerance else change vertical angle { if (avt > avd) { servov = ++servov; if (servov > 180) { servov = 180; } } else if (avt < avd) { servov= --servov; if (servov < 0) { servov = 0; } } vertical.write(servov); } if (-1*tol > dhoriz || dhoriz > tol) // check if the diffirence is in the tolerance else change horizontal angle { if (avl > avr) { servoh = --servoh; if (servoh < 0) { servoh = 0; } } else if (avl < avr) { servoh = ++servoh; if (servoh > 180) { servoh = 180; } } else if (avl == avr) { // nothing } horizontal.write(servoh); } delay(dtime); }