Answered step by step
Verified Expert Solution
Link Copied!

Question

1 Approved Answer

Title: Extraction of Copper Sulphate ( C u S O 4 ) from Pollution Control Waste Assignment Instructions: A waste material from pollution control, containing

Title: Extraction of Copper Sulphate (CuSO4) from Pollution Control Waste
Assignment Instructions:
A waste material from pollution control, containing copper oxide, underwent a leaching process with sulfuric acid, resulting in a slurry with a pulp density of 2.20 and mass fraction of solid equal to 61.54%. The concentration of CuSO4 in the solution phase of the slurry was measured to be 0.160. This slurry underwent counter-current washing in three stages as shown in Figure 1 with water. The volume fraction of liquid in the slurry remained consistent throughout the process. The volumetric flow rate of the liquid used for washing was equal to the volume of wash water. How much wash water is required to ensure that the discharge slurry contains only 1.0% of the original copper content? The solids in the slurry have a density of 5.0kgm3.
Based on your findings complete the table provided below and draw a graph showing the effect of the water flow rate on number of stages and the recovery of CuSO4.(You need to draw a graph in which y axis represents the flow rate of the wash water (or concentration of CuSO4 in slurry) and x axis shows the number of stages.
Data. The approximate specific gravity of CuSO4 solutions is: Sp.Gr of CuSO4 solution=1+wCuSO4 where w is the mass fraction of CuSO4.
Hint: use 1000L of feed slurry as your basis.
Figure 1. Flowsheet for washing leached CuSO4 from insoluble residue. Double arrows refer to slurry flow, and single arrows to solution flow.
Table 1. Mass balance for CuSO4 washing circuit (kg)
\table[[,M/S I,M/S II,M/S III],[mass fraction of CuSO 4,,,],[mass of wash liquid out,,,],[mass of CuSO4 in wash liquid,,,],[mass of slurry liquid out,,,],[mass of CuSO 4 in slurry liquid,,,],[mass fraction of CuSO 4,,,]]
Please complete sketch and complete the table and also sketch the graph
image text in transcribed

Step by Step Solution

There are 3 Steps involved in it

Step: 1

blur-text-image

Get Instant Access to Expert-Tailored Solutions

See step-by-step solutions with expert insights and AI powered tools for academic success

Step: 2

blur-text-image_2

Step: 3

blur-text-image_3

Ace Your Homework with AI

Get the answers you need in no time with our AI-driven, step-by-step assistance

Get Started

Recommended Textbook for

Introduction to Chemical Engineering Thermodynamics

Authors: J. M. Smith, H. C. Van Ness, M. M. Abbott

7th edition

71247084, 978-0071247085

More Books

Students also viewed these Chemical Engineering questions

Question

What are the degrees of freedom associated with ????e.

Answered: 1 week ago