value-sueam Costing Objective During the week of June 12, Harrison Manufacturing produced and shipped 16,800 units of its aluminum wheels: 4,200 units of Model A and 12,600 units of Model 8 , The cycle time for Model A is 0.80 hours and that of Model 8 is 0.55 hours. The total net work hours for the aluminum wheel value stream for the week were 15,000 . The following costs were incurred: 1. Assume initially thet the value-stream costs and total units shipped apply only to one model (a single-product vbue stream), Calculate the unit cost. Round your answer to the nearest dollar amount. per unit 2. Model A is responsible for 40 percent of the materials cost. Using the average conversion cost approach, calculate the unit cost for Modeis A and B. Round your answers to the nearest dollar amount. 2. Model A is responsible for 40 percent of the materials cost. Using the average conversion cost approach, calculate the unit cost for Models A and 8 . Round your answers to the nearest dollar amount. 3. What if Model A and Model B are not homogenecus products? Assume the same materlais usage as in Requirement 2 . Use Dac to calculate the unit cost for the fwo products. Round your interim calculations and final answers to the nearest dollar amount. Explain when and why this cost is mere accurate than the unt cost calculated in fleculrement 2, Explain why bec is a good approach for vaive itream coiting. DBC should be used if the products: whe: DAC more accurate as it appreaimutes AEC assignments