Question: Two technicians are discussing how heat and temperature affect conductors. Technician A says that when a conductor reaches the annealing point, the conductor's strength is

Two technicians are discussing how heat and temperature affect conductors. Technician A says that when a conductor reaches the annealing point, the conductor's strength is permanently changed. Technician B says that overhead conductors can carry more current on a hot day than they can on a cold day. Who is correct?

.

Only Technician A

.

Both technicians

.

Only Technician B

.

Neither technician

Two technicians are discussing how heat and

Step by Step Solution

There are 3 Steps involved in it

1 Expert Approved Answer

Step: 1 Unlock blur-text-image

Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock

Step: 3 Unlock

Students Have Also Explored These Related Electrical Engineering Questions!

Allegheny Ludlum Steel! Question: What is your overall evaluation of Allegheny Ludlum Steel's productivity improvement program? Discuss the productivity improvement program at Allegheny Ludlum in...

Two Technicians are discussing the rotation of the cam shaft versus the crankshaft. Technician A states that because the valves open twice for every stroke of the piston the cam shaft must spin twice...

Two technicians are discussing building PCs from scratch. Technician A says that the operating system should be installed just before final chassis assembly, in case there are compatibility issues...

Two technicians are discussing crankshaft position sensors. Technician A states that a permanent magnet sensor creates its own voltage signal as the magnetic field increases and decreases. Technician...

Two technicians are discussing secondary ignition waveforms. Technician A states that the high-voltage spike of an ignition waveform is caused by the ignition coil being turned on. Technician B...

Two Technicians are discussing engine components. Technician A states that the piston is connected to the crankshaft by the rings. Technician B states that the piston is connected to the crankshaft...

Two technicians are discussing revenue metering. Technician A says that reactive power is usually metered for a residential customer. Technician B says that demand and peak demand are independently...

Two technicians are discussing insulators and water. Technician A says that resistance stays about the same when water flows on clean or dirty insulators because water isn't a good conductor of...

Two technicians are discussing loads fed by AC circuits. Technician A says that inductive loads generate heat and light. Technician B says that AC and DC loads can both be resistive. Who is correct?...

Two technicians are discussing the wireless scan module. Technician A says the scan module is powered by an internal 9V battery. Technician B says the scan module can be paired with the Verus unit by...

In Fig P6.107 the pipe is galvanized iron. Estimate the percentage increase in the flow rate (a) if the pipe entrance is cut off flush with the wall and (b) if the butterfly valve is opened wide....

What accounting events trigger changes to the retained earnings account?

4. The dblNums array is a six-element Double array. Which of the following If clauses determines whether the entire array has been searched? a. If intSub = dblNums.Length Then b. If intSub...

Bond X is a 3% coupon bond. Bond Y is a 9% coupon bond. Bothbonds have fifteen years to maturity and make semi annual paymentsand have a YTM of 6%, If interest rates rise by 2% what is thepercentag 2...